Print Back
R-clips are commonly used to secure the ends of shafts on axles and clevis pins. The straight leg of the clip is pushed into a hole at end of the shaft. This is done until the middle of the other (belly) bent leg of the R-clip grips one side of the shaft resisting any force removing the R-clip from its hole. To assist insertion, the end of the bent leg is angled away from the straight leg.
Unit of Measure

Specifications

Length

N/A 3 in

Material

N/A Stainless Steel 316

Width

N/A 5/32 Inch

Surface Finish

N/A Black Vinyl Coated

Package Quantity

N/A 1000

Wire Diameter

N/A 0.153 - 0.158 Inch

Length Tolerance

N/A +0.080 / -0.043 Inch