R-clips are commonly used to secure the ends of shafts on axles and clevis pins. The straight leg of the clip is pushed into a hole at end of the shaft. This is done until the middle of the other (belly) bent leg of the R-clip grips one side of the shaft resisting any force removing the R-clip from its hole. To assist insertion, the end of the bent leg is angled away from the straight leg.
Unit of Measure

Length

6 in

Material

Spring Steel Wire "En42"

Width

5/16 Inch

Surface Finish

White Zinc

Package Quantity

100

Wire Diameter

0.310 - .315 Inch

Length Tolerance

+0.080 / -0.049 Inch

Why OneMonroe?

VMI - Custom Manufacturing - Technical Guides - Quality - Company Overview

Attribute Information

Quick Release Pins