Material:
Surface finish:
Note:
Indexing Plungers are used to prevent any change in locking position due to lateral forces. A new locking position can only be set after the bolt has been manually disengaged. Special grips can be fitted on the threaded head. These pins are also suitable for automated actuation of the locking bolt by pneumatic cylinder or bowden cables.
On request:
Special versions and spacer rings.
| Items |
 M65508 Indexing Plunger - No Pull Knob - Locking Pin Not Hardened - Stainless Steel - Metric |
M65492 Indexing Plunger - No Pull Knob - Locking Pin Not Hardened - Stainless Steel - Metric |
M65496 Indexing Plunger - No Pull Knob - Locking Pin Not Hardened - Stainless Steel - Metric |
M65498 Indexing Plunger - No Pull Knob - Locking Pin Not Hardened - Stainless Steel - Metric |
M65500 Indexing Plunger - No Pull Knob - Locking Pin Not Hardened - Stainless Steel - Metric |
|||||
| Material | Stainless Steel | |||||||||
| Style | E | |||||||||
| L | 24.00 mm | 32.00 mm | 37.00 mm | 42.00 mm | 56.00 mm | |||||
| D | 3.00 mm | 4.00 mm | 5.00 mm | 6.00 mm | 8.00 mm | |||||
| H | 3.50 mm | 4.00 mm | 5.00 mm | 6.00 mm | 8.00 mm | |||||
| L2 | 5.00 mm | 6.00 mm | 7.00 mm | 8.00 mm | 10.00 mm | |||||
| L3 | 3.50 mm | 7.00 mm | 8.00 mm | 8.00 mm | 12.00 mm | |||||
| L1 | 12.00 mm | 15.00 mm | 17.00 mm | 20.00 mm | 26.00 mm | |||||
| D1 | M6 X 0.75 mm | M8 X 1.00 mm | M10 X 1.00 mm | M12 X 1.50 mm | M16 X 1.50 mm | |||||
| F x 30° | 0.80 mm | 1.00 mm | 1.30 mm | 1.80 mm | 2.30 mm | |||||
| F1 - Spring Force Initial Pressure | 4.5 N | 6 N | 5 N | 6 N | 15 N | |||||
| F2 - Spring Force Final Pressure | 9 N | 12 N | 12 N | 14 N | 35 N | |||||
| L4 | 10.00 mm | 13.00 mm | 15.00 mm | 17.00 mm | 23.00 mm | |||||
| SW1 | 8.00 mm | 10.00 mm | 13.00 mm | 14.00 mm | 19.00 mm | |||||
| SW2 | ||||||||||
| D2 | M2 mm | M3 mm | M4 mm | M6 mm | M8 mm | |||||
| End Pressure Initial-Final | ||||||||||
| Diameter | ||||||||||
| Stud Length | ||||||||||
|
|
||||||||||
