Standard O-Rings are available in 369 sizes as set up by the Aerospace Standard 568 published by the Society of Automotive Engineers. These sizes are designated by dash numbers shown on the 568 DASH Chart and are standardized by imperial dimensions. Standard O-Rings are specified by their inside diameter and cross section width. AS568 is the most commonly used standard in the U.S. for aerospace, automotive and general industrial applications. For more information, please see: Comparison Properties Chart, PTFE Encapsulated O-rings, Material Shelf Life, and O-ring Groove Design Chart. EP is also known as: Eythylene Propylene, EPR, EPDM, EPT, E.
EP is an elastomer which is characterized by wide range of applications and good chemical resistance. Ethylene propylene compounds have good resistance to detergents, alkalis, mild acids, greases, silicone oils, and alcohols.
EP is an elastomer which is characterized by wide range of applications and good chemical resistance. Ethylene propylene compounds have good resistance to detergents, alkalis, mild acids, greases, silicone oils, and alcohols.
Unit of Measure
Cross Section Width |
N/A 0.103 in |
Durometer |
N/A 70 |
Inside Diameter |
N/A 196.52 mm7.737 in |
Cross Section Tolerance +/- |
N/A 0.003 in0.08 mm |
Inside Diameter Tolerance +/- |
N/A 0.045 in1.14 mm |
Size Reference - AS568 |
N/A -170 |
Warning |
N/A Prop 65 Warning: This product may contain chemicals known to the State of California to cause cancer, and birth defects or other reproductive harm. |
O-Ring Industries |
N/A O-rings are used in the military defense and agriculture industries. |
