Material:

  • Steel version: pressure foot in tempered steel. Ball element in case-hardened free-cutting steel
  • Stainless steel version: pressure foot and ball element in stainless steel
  • Surface finish:

  • Steel version: pressure foot black oxide finish. Ball element in case-hardened; black oxide finish
  • Stainless steel version: natural finish
  • Damper plate PUR elastomere, gray, fixed, cannot slip. range of use from -30 °C to +70 °C. Damper plate PUR elastomere (Sylomer V12).

    Note: The manageable load given in the table is a recommendation of the permanent static load up to which the absorption unit should be used. This static load corresponds to a pressure per area of 0.4 N/mm², at which the material reaches its optimum absorption properties. Here it is taken into account that under dynamic demands an additional load, up to 0.6 N/mm² may occur. The damper plate absorbs vibrations and prevents slipping of the Swivel Foot. Swivel Foot (without vibration absorption) see 07144. This is a Kipp Original Design.

    Unit of Measure

    Material

    N/A Steel

    D2

    N/A 40.00 mm

    D3

    N/A 31.00 mm

    H2

    N/A 6.00 mm

    H1

    N/A 26.00 mm

    T

    N/A 12.00 mm

    D1

    N/A M12 mm

    SW

    N/A 19 mm

    H3 (under pressure of 0 / 0.4 / 0.6 N/mm²)

    N/A 8 / 6.8 / 5.9 mm

    Load capacity (under pressure of 0.4 N/mm²)

    N/A 212 N

    Country of Origin

    N/A -

    Warning

    N/A Prop 65 Warning: This product may contain chemicals known to the State of California to cause cancer, and birth defects or other reproductive harm.