Monroe
OneMonroe
Locations Throughout the Country
ISO 9001:2015
Tel: (877) 740-2007
Fax: (800) 453-9683
Email: sales@askmonroe.com
Website: monroeengineering.com
Print Back
R-clips are commonly used to secure the ends of shafts on axles and clevis pins. The straight leg of the clip is pushed into a hole at end of the shaft. This is done until the middle of the other (belly) bent leg of the R-clip grips one side of the shaft resisting any force removing the R-clip from its hole. To assist insertion, the end of the bent leg is angled away from the straight leg.
Unit of Measure

Specifications

Length

 N/A 4.5 in

Material

 N/A Stainless Steel 316

Width

 N/A 1/4 Inch

Surface Finish

N/A Clear Zinc

Package Quantity

 N/A 400

Wire Diameter

 N/A 0.232 - 0.240 Inch

Length Tolerance

 N/A +0.080 / -0.047 Inch