Print Back
R-clips are commonly used to secure the ends of shafts on axles and clevis pins. The straight leg of the clip is pushed into a hole at end of the shaft. This is done until the middle of the other (belly) bent leg of the R-clip grips one side of the shaft resisting any force removing the R-clip from its hole. To assist insertion, the end of the bent leg is angled away from the straight leg.
Unit of Measure

Specifications

Length

4.375 in

Material

Stainless Steel 304

Width

7/32 Inch

Surface Finish

White Zinc

Package Quantity

500

Wire Diameter

0.212 - .220 Inch

Length Tolerance

+0.080 / -0.046 Inch