Welding Preheat System – Quad System
The Quad Controller is designed for 100A, 3 phase, 3 pole, 4 wire primary input and has 3 pole, 4 wire receptacles for secondary output. You can run 6 heaters per each 4FJ20 panel mount receptacle output for a total of 24 heaters per Controller. The controller’s output is rated 48 KW at 460 Volts. The unit is portable and lightweight with dimensions of 16 x 17.75 x 14.25 and weighing only 32.01 lbs. It also comes with Power Available indicators, Blown Fuse indicators and a Disconnect Switch. The unit comes with a Percentage Timer, which controls the heating time of your system and allows you to alter the systems requirements to each application.
The Quad Controller allows you to run your preheat on a totally dedicated system to maximize efficiency.
/Asset/Integro-Products-Steel-Fabrication-Welding-Preheat-System-Quad-System-600x600-1.jpgWelding Preheat System – Single System
The Single Controller is designed for 30A, 3 phase, 4 wire primary input and has a single outlet for secondary output. The Single Controller is designed to operate a total of 6 heaters. The controller’s output is rated 12 KW at 460 Volts. This smaller unit is even more portable and lightweight with dimensions of 13? x 13.5? x 12.25? and weighing only 19.30 lbs. It has all of the other features mentioned above.
The Single Controller allows you to run your preheat on a totally dedicated system to maximize efficiency.
/Asset/Integro-Products-Steel-Fabrication-Welding-Preheat-System-Single-System-600x600-1.jpgWelding Preheat System – Power Streamer
Power Streamers are used to take the 4 contact, 3 phase power input from the Controller and distribute that power to 6 outlets for each individual strip heater to plug into. Each 3 phase power streamer has a 4MJ20 (male) 4 contact, 3 phase input on 12/4 SOW Cable that plugs into the Controller. There is 50' of cable leading into 6 taps, each spaced 3' apart. Each tap has a 15FR (female) receptacle on 14/3 SOW Cable, 6' long. Total length is 65'.
/Asset/Integro-Products-Steel-Fabrication-Welding-Preheat-System-Power-Streamer.jpgWelding Preheat System – Strip Heaters
(4)Preweld Strip Heaters are made with a cast aluminum shoe and a flat cover to heat your steel application to appropriate preweld and postweld temperatures. They are designed with hanging slots so you can drive a stud and hold them in place. Each strip heater has a 15' input cord with a 15MP3 male connector that plugs into the power streamer. They come in 4 different sizes and can be ordered in any combination to handle your specific applications.
/Asset/Integro-Products-Steel-Fabrication-Welding-Preheat-System-Strip-Heater-600x600-1.jpg